电话Service Hotline

15120088920

Home > news > Content

company's product

Beijing Liang Industrial Precision Machine Technology Co., Ltd.
Service Hotline: 13552946620
Contact: Talk Manager
Mobile: 13717861982
Tel: 010-69395198
Fax: 010-80303272
Website: WWW.bjlgjj.com
Address: No. 1th Liu Xialou, Liyuan store village, Shilou Town, Fangshan District, Beijing
Bus line: Beijing West railway station South Square walk to six miles Qiaodong take 835 express or 917 express bus to Tian Family Garden District station to get off transfer Room 11 road to Liyuan shop East station get off
Dongguan Liang Precision machine CNC machine Tool Co., Ltd.
Contact: Manager du
Mobile: 15120088920
Fax: 0769-82752550
Address: No. 7th Xia Chun Road, Langzhou village, Changping Town, Dongguan, Guangdong Province
Bus route: Dongguan East Station take No. 6 bus to Langzhou Village station to get off

What are the details of the CNC engraving and milling machine for routine maintenance?

CNC engraving and milling machine is an important part of the processing market in the past few years. The demand for CNC engraving and milling machine in the processing market is becoming more and more obvious. Compared with the ordinary engraving and milling machine, the CNC engraving and milling machine increases the power of the main shaft and is equipped with imported Servo motor, the rigidity of the body is also enhanced to withstand the increase, to maintain the high speed of the spindle, and more importantly, the precision is better than the engraving machine. The CNC engraving and milling machine has a larger cutting capacity and a better surface finish. These features of CNC engraving and milling machine put forward higher requirements for our daily machine maintenance. Today we will learn about the maintenance and maintenance of CNC engraving and milling machine.

In the process of using CNC engraving and milling machine, the main fault is mostly due to the wear of machine parts. If the processing is not timely, it will affect the normal machining accuracy of the machine tool and the service life of the machine tool. The maintenance of the machine tool can be done in the following aspects.

1. When the CNC engraving and milling machine is running, it is necessary to ensure that the surface of the machine tool is clean and there is no other debris, otherwise it will cause irreversible wear on the rail surface and the slider.

2. Maintain the linear guides on time, usually by adding an appropriate amount of rail oil, and pay attention to whether the rail oil consumption is normal. If the rail oil consumption is found to be too low, check if the oil circuit is normal and the lubrication is sufficient.

3. During the long holiday of the Spring Festival, put the butter on the spindle hole and put a proper amount of desiccant with a protective film to seal it. The method does not use for a long time and causes the internal components of the spindle to rust.

4. Check once a week in the electric control cabinet whether there is oil and clean it with a dry rag in case of power failure.

5. When machining, the maximum speed of the spindle can only be set at 80% of the high speed. If the speed is too high, the components of the spindle will be accelerated and the service life will be shortened.

In the daily processing process, the CNC engraving and milling machine can be maintained according to the above points to ensure the normal service life of the machine tool.